Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (102.01 KB, 1 trang )
syringe with heparin flush solution (10 U/mL); transparent sterile dressing.
Consider use of ultrasound to identify artery (static approach) or track
cannulation (dynamic approach) (see Chapter 131 Ultrasound ).
Procedure
Assess the adequacy of both radial and ulnar arterial flow by palpation before the
puncture. The modified Allen test assesses ulna arterial flow more completely and
is performed as follows. Compress both the radial and ulnar arteries firmly with
three fingers on each artery. Have the patient clench and unclench the fist 10
times until the palm is blanched. Have the patient relax the hand without fully
extending the fingers. Release the pressure on the ulnar artery. If the thumb and
thenar eminence regain normal color within 5 seconds, then the ulnar collateral
circulation is sufficient to support radial artery cannulation.
For arterial puncture, attach the butterfly to the syringe and flush the system
with the heparin solution and empty it. Have the assistant firmly restrain the
infant or child by holding the arm just proximal to the wrist in supination and
hyperextending the hand approximately 20 to 30 degrees.
Using gentle pressure with the gloved palpating fingers, locate the vessel.
Ultrasound can be useful to identify the vessel or dynamically follow the needle.
Cleanse the skin overlying the radial artery with the antiseptic solution. Hold the
needle as shown in Figure 130.3 and pierce the skin between index and middle
fingers of the palpating hand, directing the needle at 30 to 60 degrees from the
horizontal plane. When the needle enters the radial artery, blood will flow into the
butterfly tubing. Slight suction should be applied to fill the syringe. If the initial
thrust is unsuccessful, attempt to enter the artery from a different angle, either
medially or laterally as determined by careful palpation. To reduce the likelihood
of vessel injury, partially withdraw the needle before advancing during reattempts
and minimize the number of punctures.
After obtaining the specimen, remove the needle and apply manual pressure to
the puncture site for 5 minutes. Any air bubbles must be immediately removed
from the sample syringe to achieve accurate blood gas results.