COFFEEͳBREAK ORIGAMI
23
6 Turn the model over so
7 Pick up the right edge
8 Bring the mountain fold
9 Pick up the left edge
that it looks like the position
shown in the next step.
releasing the flap
underneath.
to the vertical crease and
press the new fold flat.
releasing the flap
underneath.
12 Turn the model over so
13 Make a little valley fold
that it looks like the position
shown in the next step.
at the top right corner. Fold
the front flap (it will be the
beak) to the right.
10 Bring the mountain
fold to the vertical crease and
press the new fold flat.
11
Fold the bottom corner
up to the indicated point.
(Note: the point that
is referred to is located
approximately halfway between the horizontal crease
and the top corners of
the front flaps.)
16 Cut a rectangle from
14 Make a little valley fold
at the top left corner. Stand
the flap (that will be the
beak) up at a right angle.
Ori for Busy People_INT 00-96 27jul.indd 23
15 Pull down the bottom
back flap to an angle that is
a little less than a right angle.
card stock or medium weight
bond paper that you will
use as a place card and then
insert the card under the flap
of the model. Your Placard
Bird is ready for company.
Barry B. Miller is
interested in science
and protecting the
enviroment. He likes
antique microscopes,
exotic houseplants, and
mineral collecting.
7/27/11 3:54:44 PM