Tải bản đầy đủ (.pdf) (2 trang)

ORIGAMI đơn GIẢN 32

Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (418.52 KB, 2 trang )

Intermediate

Extraterrestrial
Created by Marcia Joy Miller
Add a touch of mystery to your origami display shelf
with Extraterrestrial.

PAPER: Create the model from the designated sheet of
folding paper included in the back of the book on page
139. You can also use a 6 to 10-inch square of origami
paper.

1 Start with a completed

2 Sharply fold the corner

Waterbomb Base. Sharply
fold the top corner down
approximately one-third of
the height of the model.

to the top edge. Open the
model completely.

3 Redefine the small center

4 Make a pleat fold with the

square with valley creases.
Extend the top crease of that
square to the edges.



two long horizontal creases.

5 Bring A and B down to

6 Bring D down to meet A,

meet C. The result is threedimensional.

B, and C. Then, flatten the
model.

BASIC TECHNIQUES: See Chapter 1 for the Reverse
Fold and Waterbomb Base exercises.

Ori for Busy People_INT 00-96 27jul.indd 51

7/27/11 3:56:14 PM


52

ORIGAMI FOR BUSY PEOPLE

7 The front and back top edges differ

8 Fold the top edges down. Turn the

9 Make the creases on the right front


in thickness. Keeping the thinner edge
in front, make the partial creases using
the triangular shape that you can feel
within the layers as a guide.

model over from side to side.

flap. (The leftmost crease may be
vertical or slightly angled.) Repeat on
the left front flap.

10 Make the inside reverse fold

11 Make an inside reverse fold on the

12 You have made a double reverse

placing the reversed corner under the
front layer.

existing creases.

fold. Repeat steps 10–11 on the left flap.
Turn the model over from side to side.

13 Fold the left corner to the raw edge 14 Make an inside reverse fold

15 Make a pleat fold to form a hand

as indicated.


so that the tip of the hand will rest to
the left of the vertical crease.

Ori for Busy People_INT 00-96 27jul.indd 52

treating both layers as one.

7/27/11 3:56:17 PM



Tài liệu bạn tìm kiếm đã sẵn sàng tải về

Tải bản đầy đủ ngay
×