Build A Remote-Controlled Robot Part 6 pot

FIGURE 2-6. Drilling and cutting guide.
FIGURE 2-7. Drilling and cutting guide.
BODY FRAMEWORK 19
that piece. The figures depict each piece as if it were laid
lengthwise with its two edges on a workbench then flattened
so both sides could be seen. All the figures show the locations
and diameter of the holes to be drilled. The locations of the
45-degree angle cuts to be made at the ends of many of the
aluminum pieces are shown as shaded areas where the alu-
minum is to be removed.
Most of the figures are duplicates of each other. The dif-
ference between the figures are numbers and sometimes let-
ters that appear on the sides of each aluminum piece. The
numbers are used when the framework is assembled to the
two main sections that make up Questor’s body. The letters
are used when these sections are joined together by two con-
necting pieces to form the completed framework. In both
cases the symbols ensure that all the predrilled holes are
in their correct locations when the framework is completed.
To mark the numbers and letters on the outsides of each
FIGURE 2-8. Drilling and cutting guide.
20 CHAPTER TWO
FIGURE 2-9. Drilling and cutting guide.
BODY FRAMEWORK 21
FIGURE 2-10. Drilling and cutting guide.
22 CHAPTER TWO
FIGURE 2-11. Drilling and cutting guide.
BODY FRAMEWORK 23
FIGURE 2-12. Drilling and cutting guide.
24 CHAPTER TWO
FIGURE 2-13. Drilling and cutting guide.

FIGURE 2-14. Drilling and cutting guide.
BODY FRAMEWORK 25
FIGURE 2-15. Drilling and cutting guide.
FIGURE 2-16. Drilling and cutting guide.
26 CHAPTER TWO
FIGURE 2-17. Drilling and cutting guide.
FIGURE 2-18. Drilling and cutting guide.
BODY FRAMEWORK 27
FIGURE 2-19. Drilling and cutting guide.
FIGURE 2-20. Drilling and cutting guide.