Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (103.69 KB, 2 trang )
Activating Tube & Pipe after opening an
assembly hangs Inventor 2014
Issue:
Users reported that after launching Inventor 2014
•
if an existing assembly (without tube and pipe elements)
is opened
•
then entering in Tube and Pipe environnement
•
Inventor can hang
Note: generally this incident is visible when:
•
opening migrated assemblies
•
using localization releases of Inventor (like french or
german)
•
using Inventor 2014
Solution:
Status: This incident has been resolved in Autodesk Inventor
Professional 2015.
Incident ID: 30871
Workaround Option 1:
•
Generating a system variable can solve the problem:
•
Variable name: DYNAMIC_LOAD_APPLETS
•
Variable value: 0