Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (8.17 KB, 2 trang )
1 - 2 IT Essentials II v2.0 - Lab 11.5.9 Copyright 2002, Cisco Systems, Inc.
Lab 11.5.9: Installing SNMP
Estimated Time: 20 minutes
Objective
Upon completion of this lab, the student will be able to set up monitoring agents to run
tests and alerts for the system.
Equipment
• A PC with Windows 2000 Professional.
Scenario
To monitor the network, Simple Network Management Protocol (SNMP) must be
installed.
Procedures
Install the SNMP service and configure the agent properties.
Step 1
Click Start> Settings> Control Panel> Add/Remove Programs.
Step 2
In the Add/Remove Program window, click Add/Remove Windows Components. Wait
a few seconds for the Wizard to load up.
List some of the Windows Components that are already installed on the PC.
__________________________________________________________________
Step 3
Put a checkmark in the box next to Management and Monitoring Tools, and then click
Next.
Step 4
After the proper files are installed, click Finish. This will conclude the installation of
SNMP. The network performance can now be monitored.
Step 5
Close all windows.
Now that SNMP has been installed, configure the agent properties in SNMP.
Step 6