Tài liệu CINCI-CCIE-LAB-SCENARIO 1 pptx

CVG-CCIE Practice Lab
Last modified 01/25/00
Cisco Systems Channel Partners Only - Confidential Information. This information
may not be redistributed without written authorization from Cisco Systems, Inc.
1
CVG-CCIE
Practice Lab
CVG-CCIE Practice Lab
Last modified 01/25/00
Cisco Systems Channel Partners Only - Confidential Information. This information
may not be redistributed without written authorization from Cisco Systems, Inc.
2
Physical Layout
Diagram 1
Frame
Relay
S1
S2
L0
Happy
S 1
S 0
E 0
Token
Ring
Grumpy
Dopey
Sleepy
S 0
These routers are physically connected together as shown.
Token

Ring
E0
E0
E0
S 0
S 0
S 0
E0
T0
T0
S3
S0
Sneezy
ISDN
BRI 0
BRI 0
CVG-CCIE Practice Lab
Last modified 01/25/00
Cisco Systems Channel Partners Only - Confidential Information. This information
may not be redistributed without written authorization from Cisco Systems, Inc.
3
Grumpy
Dopey
Sleepy
E0
Line 3
Line 4
Comm Server
ASET #3 2511
IP Address: 216.68.103.150

Comm Server Setup
Diagram 2
Line 1
Line 2
Sneezy
Happy
Line 5
CVG-CCIE Practice Lab
Last modified 01/25/00
Cisco Systems Channel Partners Only - Confidential Information. This information
may not be redistributed without written authorization from Cisco Systems, Inc.
4
Routing Topology
Diagram 3
Frame
Relay
S1
S2
L0
Happy
S 1
S 0
E 0
Token
Ring 2
Grumpy
Dopey
Sleepy
S 0
Token

Ring 1
E0
E0
E0
S 0
S 0
S 0
E0
T0
T0
S3
S0
Sneezy
ISDN
BRI 0
BRI 0
RIP
OSPF Backbone Area
IGRP
EBGP
VLAN 3
VLAN 2
IBGP
EIGRP
Area 2
Area 3
Area 4
CVG-CCIE Practice Lab
Last modified 01/25/00
Cisco Systems Channel Partners Only - Confidential Information. This information

may not be redistributed without written authorization from Cisco Systems, Inc.
5
Lab 1
Communications Server Setup / Network Connections
• The Communications Server is cabled as shown on the previous diagram.
• For the purposes of this practice lab, you are coming into a pre-configured
communications server. To see the hosts names type “show hosts” and you
will be presented a list of them. Ordinarily you will configure the
Communications Server so that when you type the name of a router on the
Server you are connected to the console port of that respective router. You
should know how to do this.
• Review all of the steps in the following labs and create a network diagram on
a separate piece of paper. Include the network numbers, network address
ranges, and subnet mask for each network on the diagram.
TIME: 20 minutes