Tài liệu Removing Doors of the Cabinet pdf

OptiX OSN 3500
Installation Manual Contents
Contents
2 Removing Doors of the Cabinet.................................................................................................1
2.1 Removing the Front Door....................................................................................................................2
2.2 Removing the Side Doors....................................................................................................................3
Issue 05 (2006-11-20)
Huawei Technologies Proprietary
i
OptiX OSN 3500
Installation Manual Figures
Figures
Removing the front door..................................................................................................................2
Removing side doors........................................................................................................................3
Issue 05 (2006-11-20)
Huawei Technologies Proprietary
iii
OptiX OSN 3500
Installation Manual 2 Removing Doors of the Cabinet
2 Removing Doors of the Cabinet
About This Chapter
This chapter guides you to remove side doors and the front door of the cabinet.
Remove the front door first, then the two side doors.
The following table lists the contents of this chapter.
Section Description
2.1Removing the Front Door Describes operations and procedures of removing
the front door of a cabinet.
2.2Removing the Side Doors Describes operations and procedures of removing
the side doors of a cabinet.
Issue 05 (2006-11-20)
Huawei Technologies Proprietary

1
2 Removing Doors of the Cabinet
OptiX OSN 3500
Installation Manual
2.1 Removing the Front Door
Purpose
This procedure guides you to remove the front door before
cabinet installation.
Tools/Materials
None
Prerequisites
The cabinet has been delivered to the site.
Required/As needed
Required
Step 1 Pull down the suspension ring in the upper right corner of the front door. See Step
2Figure 1.1.
Step 2 Hold the front door with both hands and pull it out of the axis seat at the bottom of
the cabinet. See Figure 1.1
A
A
Fixed axis
Axis seat
Movable
door axis
Suspension
ring
2
1
Figure 1.1 Removing the front door
2

Huawei Technologies Proprietary
Issue 05 (2006-11-20)
OptiX OSN 3500
Installation Manual 2 Removing Doors of the Cabinet
----End
2.2 Removing the Side Doors
Purpose
This procedure guides you to remove the side doors of the
cabinet before cable installation.
Tools/Materials
Screwdriver
Prerequisites
The cabinet has been delivered to the site.
Required/As needed
Required if there are E1 cables to be routed in the cabinet.
Step 1 Disconnect the ground cable of the side doors.
Step 2 Loose the six screws from the side door and put the side door aside. See Figure 1.1.
Figure 1.1 Removing side doors
Step 3 Remove the other side door in the same way.
----End

Issue 05 (2006-11-20)
Huawei Technologies Proprietary
3