Xếp hình con cừu pot

Designed and diagrammed by Andy Carpenter (1998).
Use a sheet of strong white paper (white on both sides) with
dimensions of 1: 1.8.
A sheet 30cm by 54cm will produce a model approximately
14cm by 9cm.
Wet fold the paper for best results.
Sheep
1. Precrease before wet folding.
2.
3.
4. Enlarged view. Thin
the face/horns & fold in
half. Points A & D from
step 3 are hidden by
another layer of paper.
5. Rabbit ear the horn, thin the vertical
raw edge from head to front legs, then
sink fold the front legs with two layers of
paper on each side.Crimp fold to form the
back leg. Repeat behind.
6. Enlarged view. Reverse fold both sides
of the back leg. The fold on the right
trisects the angle. Repeat behind.
Front leg
Horn
Body
7. Repeat behind.
8. Front left side of model cut away.
Rabbit ear fold both front legs.The one
shown is the far side front leg.
9. Repeat behind.

A
B
D
C
C
B
A
D
E
F
E
F
A
B
C
D
Copyright Andy Carpenter (1998)
14. Repeatedly crimp fold to curve
the horn. Repeat behind.
15.Fold to shape the body.
Repeat behind.
16. The final sheep.
10.
11. Repeat for all 4 feet.
12. Like this
13. Push the face down and pull the
back of the head up. Fold to shape
head and horns. Repeat behind.
Copyright Andy Carpenter (1998)