Tải bản đầy đủ (.docx) (2 trang)

SSOP kiểm soát động vật gây hại

Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (42.86 KB, 2 trang )

PESTS CONTROL
PURPOSE AND REQUIREMENTS:
Must prevent and effectively exterminator pests (insects, rodents ...)
II. CURRENT COMPANY’S CONDITION:
- The factory which is surrounding by high walls, adjoins residential areas and
gardens.
- Prevention System:
+ The factory’s systems of sluice gates and drainage ditches are covered by
meshes to block rats’ penetration points.
+ Doors and windows in each areas of factory have been always kept closed
and covered by blinds.
- Extermination System:
+ Rodents trap system.
+ Weekly spraying with insecticides and cleaning around the factory.
III. REQUIRED PROCEDURES:
3.1 System maintenance
Regular system inspection and maintenance to prevent pest intrusion: Fencing,
doors, windows, raw materials entry doors, curtains, manhole covers, hatches
sewer...
3.2 Remove the Enticement place
- The waste containers are always covered by lids.
- The manholes, drainage ditches in the factory must be cleaned at the end of
day
- The broken (damaged) production tools, equipment, machines must not be
placed in the factory or surrounding areas.
- Keep the surrounding environment of the factory clean to eliminate the
breeding ground of pests.
*. Frequency: once per week.
*. Follow the contents of Section 3.3.8 SSOP1.4.
- Do not allow cattle and poultry get in the factory.
3.3 Pest Extermination Plan:


- Extermination plan:
+ Planning to set rodents traps and trapped rodents treatments follow KH08 SSOP1.
+ Planning to spray insecticides, follow KH08 - SSOP1.
- Where to place traps:
+ Placing traps follows SD04 - SSOP1.
IV. MONITORING AND RESPONSIBILITY ASSIGNMENT:
I.

Page 1/2


4.1 Monitoring:
- QC has been assigned the responsibility to supervise and inspect the
implementation of this Guideline.
- Mechanical Engineering Department maintains and repairs: rodents traps,
sprayers, manhole covers, hatches sewer, doors, doors’ curtains...
4.2 Responsibilities Assignment:
- Director implements and maintains these rules.
- Division of Engineering & Quality Management plans the pests control
programs and proposes to General Director of the Company for approval.
- Pesticide Team and Operation Team comply with these rules.

Page 2/2



×