AL FORM dismantling tool manual EN
Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (9.66 MB, 20 trang )
DISMANTLING TOOLS
MANUALS
Kumkang Kind’s
AL-formworks system
11/3/19
1
Part 1: PIN & WEDGE
DISMANTLING PROCESS
11/3/19
page 2
Strike the Wedge directly
11/3/19
Page 3
Strike the Wedge
With the assembling tool
11/3/19
Page 4
Part 2: WALL PANEL
DISMANTLING PROCESS
Notes: to protect the extended wall panel
we must dismantle the panel from the top.
11/3/19
page 5
Dismantling tool
11/3/19
Page 6
Supporting point
1
Up
Notes: the extended form area is very weak and
easy to be broken under too much strength. So
this area should be gently treated.
11/3/19
Page 7
Up
Up
11/3/19
Page 8
Optional & not reccommended!
Only used when the previous work cannot help.
If neccesary, do it slowly & gently
11/3/19
Page 9
1
Down
1
Supporting point
Supporting point
BEFORE
11/3/19
AFTER
Page 10
11/3/19
Page 11
11/3/19
Page 12
Pull out
11/3/19
Page 13
Swing to protect
the panel footing
11/3/19
Page 14
Part 3: SLAB PANEL
DISMANTLING PROCESS
11/3/19
page 15
After removing the pin & long pin
dismantle the Beam
Down
11/3/19
Page 16
Beam dismantled
11/3/19
Page 17
Dismantle the slab panel
Dismantling tool
11/3/19
Page 18
Dismantle the slab panel
11/3/19
Page 19
Thank you for your attention!
11/3/19
page 20
