Chart móc bé trai bằng len

design by serah basnet | tales of twisted ibers


Materials

Special Notes

• Sock weight yarn in black, brown, blue, light
peach, grey, red, white
• 2.5mm crochet hook
F
• 12mm black safety eyes
A
• A pair of scissors
T
• Yarn needle
• Sewing needle
• Sewing Pearl headed pins
S
• Black sewing thread
• Keychain
M
I
silver]
• 16 gauge wire
W
• Masking tape

4-dc Bobble Stitch
YO, insert hook in the next st, pull yarn through, YO,
YO

insert hook in the same st, pull yarn through, YO,
YO
insert hook in the same st, pull yarn through, YO, pull
YO
hook in the same st, pull yarn through, YO, pull yarn
YO

Back/Front Post Single Crochet Stitch
For Back / Front Post Single Crochet, there is an
excellent photo and video tutorial by Tamara Kelly
here:
single-crochet/

SIZE: 8.5 inch when made with the indicated yarn
DIFFICULTY: I

Terminology [US]
ch (chain)
magic ring
sc (single crochet)
dc (double crochet)
BLO (back loop only)
bpsc (back post single crochet)
fpsc (front post single crochet)
inc (increase)
dec (decrease)
4-dc bobble st

© 2018 Tales of Twisted Fibers
All rights reserved.

You may not sell/redistribute/translate/publish this
F
Tales of Twisted Fibers as the designer.
22


Instructions

Rnd 6-7:
Rnd 8:
Rnd 9:
Join brown yarn.
Rnd 10: BLO
Rnd 11: BLO
S
Rnd 12-17:
Rnd 18:
X
Rnd 19-20:
L
C
T
F

S

SHOE & LEG [make 2]
Note: Before you start working on the shoe, cut a
12-inch strand of black yarn and keep it aside. You
will need it to sew the sole to the shoe.

Right leg: sl st in the next 8 st. Mark the last
S
N

With black yarn, ch 8.
Rnd 1: S

BODY
Hold both legs together, the leg with the ‘live’
C
Make sure the toes are facing away from you.

Rnd 2:
Rnd 3:
Rnd 4:
Make the Sole: O
C
by the back post sc in Round 4. Trim further
if required. Make 2 holes in the center, a few
M

Rnd 5:
Insert sole: P
of the sneaker, thread a yarn needle with black
yarn, and holding both pieces together, insert the
needle from inside to out through the hole and
from outside to in through the second hole. Knot
the yarn ends together to secure P
.

Rnd 1: W
I
this leg P
N
loop facing you) of the ch 1 you made earlier. sc in
Rnd 2: sc 1 in the front loop of the ch 1 you made
in the previous round. sc in the remaining 42 st
Rnd 3-4:
Join black yarn.
Rnd 5: BLO
Rnd 6: BLO
Join blue yarn.
Rnd 7: BLO
Rnd 8: BLO
Rnd 9:
Rnd 10:
Rnd 11-13:

X

ASH WILLIAMS | ASH VS EVIL DEAD by tales of twisted fibers

3


Rnd 14:
X
Rnd 15-18:
Rnd 19:

X
Rnd 20-21:
S
Join light peach yarn.
Rnd 22:
X
Rnd 23-30:
I
possible at this point so it can support the weight of
the head.
Rnd 31:
X
F
U
weave the yarn tail through the front loop of each
Weave in the yarn end.

Rnd 2:
X
Rnd 3:
Join blue yarn.
Rnd 4: BLO
Rnd 5: BLO
Rnd 6-19:
F

CHAINSAW
C
C
Row 1: S

Row 2:
F

S
D

SHIRT COLLAR
Ch 21 with blue yarn.
Row 1: 2 dc in fourth ch from the hook, dc in the next

F

W
the chainsaw together.
Base
Work with red yarn.
Rnd 1:
Rnd 2:
Rnd 3:
X

ARM [make 2]
Start with light peach yarn.
L A
Rnd 1:
Rnd 2:
X
Rnd 3:
X
Rnd 4-5:

Rnd 6:
Rnd 7:
X
Join blue yarn.
Rnd 8: BLO
Rnd 9: BLO
Rnd 10-23:
F
for sewing.
Right Arm
Rnd 1:

4

ASH WILLIAMS | ASH VS EVIL DEAD by tales of twisted fibers

Rnd 4:
X
F
S
P

. We are doing this so that the
W

P
the base as shown in P

Body
Work with red yarn.

Rnd 1:
Rnd 2:

. Make sure you do
R


Rnd 3:
X
Rnd 4:
X
Rnd 5:
Rnd 6-10:
F
W

X

Saw [make 2]
Ch 11 with grey yarn.
Row 1: S

L
the base over the open end P

C

.

S

Row 2:
F

W

M
Keep the last worked st on the hook.
Hold the two pieces together, wrong sides facing
N
W
will now join the two pieces and make the teeth
of the saw by working on the back loop of the
piece close to you and the front loop of the
P
.
C
X
F
chainsaw
P
.
Handlebar
Ch 8 with black yarn.
Row 1: S
ch 7.
F
chainsaw
P

.

Starter recoil cover
Rnd 1: With grey yarn, 8 sc in a magic ring, sl st
F
chainsaw

P

MAKE MOVABLE ARMS
The next step involves working with wires so that
your doll’s arms are poseable.
M
above the chest where the wire will go through
T
wire needed.
W
eyelet. Wrap a masking tape around the eyelet to
I
I
where the arm will be placed—this will be on Rnd
P
to the other side where the second arm will be
B
masking tape, insert this wire into the second arm
N
Rnd 18 and 20 of the body and sew them in place
P
F
T
sides of the body.

SHIRT DETAILS
Note: See Pic 16 for reference.
Thread a yarn needle with blue yarn and sew two

.

ASH WILLIAMS | ASH VS EVIL DEAD by tales of twisted fibers

5


01

02

03

04

05

06

07

08

09

10

11

12

13

14

15

6

ASH WILLIAMS | ASH VS EVIL DEAD by tales of twisted fibers


01
16

02
17

03
18
6th stitch
1st stitch

04
19

21

05
20

remove
split ring

22

23

24
attach
here

25

attach
here

26

27
sew
here

sew
here

28

29

30

tie
here

tie
here

ASH WILLIAMS | ASH VS EVIL DEAD by tales of twisted fibers

7


31

32

S
these two lines.
Sew the shirt collar around the base of the neck.
With grey yarn, embroider a belt buckle. With brown
yarn, embroider belt loops over the belt, two at the
front and three at the back.

HEAD

Rnd 1: W
Rnd 2:
X
Rnd 3:
Rnd 4:
Rnd 5:
Rnd 6:
Rnd 7:
Rnd 8-20:
Rnd 21:
Rnd 22:
Rnd 23:
Rnd 24:
I
Rnd 25:
X
F

EAR [make 2]
Row 1: W
Row 2:
F

HAIR
Note: We will make the hair in two parts: [i] the basic

X
X
X
X

X

are sewn together.
Top
Rnd 1-8: F
Back – Part I
From here onwards, we will work in rows.
Row 1-5:
Row 6:
Row 7:
Row 8-9:

X
X
X
X
R
S

EYES, EYEBROWS & NOSE
Note: See Pic 17 for reference.
Thread a yarn needle with white yarn and embroider a
crescent shape around the outer eye.
With two strands of black sewing thread, embroider
R
T
R

8

33

ASH WILLIAMS | ASH VS EVIL DEAD by tales of twisted fibers

Sideburns
N
Row 1-2:
Row 3:
F
With the “right” side of the facing you, mark the 1st
P
. Join black yarn on the 1st
W
Row 1-2:
Row 3:
F


Back – Part II
Join black yarn on the next marked st.
Row 1:
L
Row 2-4:
Row 5:
Row 6:
Row 7:
Row 8:
F
Put the hairpiece on the head, aligning the magic
ring of the hairpiece with that of the head, and

M
between the sideburn and the back of the hair.
Sew ear in this gap. Thread a yarn needle with
grey yarn and sew grey streaks on the sideburn
P
.

JOIN HEAD TO BODY
Note: This head-body joining technique ensures
that the head of your amigurumi is movable.
Thread black yarn and insert the needle from the
case, the wig] and out from the neck opening P
20] N
R
through the neck opening on the head, bringing it
out again from the magic ring on the head. Slide

perfectly on the neck. Knot the yarn ends together
C
carefully push remaining yarn back into the head.

HARNESS
Straps
Work with black yarn.
First piece:
Second piece:
Third piece:
Holster
Ch 4 with black yarn.
R

S

R
R
R
R
R
R
R
R
F

BLO
X
X
X

Assembling the Harness
Remove the split ring from the keychain. You
will need only the 2 jump rings and the four
P
. Place the
keychain over the right shoulder so that one jump
sits just below the shoulder at the front and the
other at the back P
.
T
arm, and ends at the back of the right shoulder
P
.

T
the front of the right shoulder, right next to the
I
to the jump ring at the back P

.

ASH WILLIAMS | ASH VS EVIL DEAD by tales of twisted fibers

9


T
the right side of the belt at the back P
.
Sew the holster to the harness at the back as shown in
Pic 28.
S

HAIR
Front Piece [make 2]
W
C
Cut another long strand of yarn, about 16 inches in
end P
C
the strands at the opposite end.

Pin one end of this hairpiece at the center of the
forehead, just along the hairline, and the opposite end

at the back of the head as shown in P
. Sew
both ends in place.
P
P
. Pin the hairpiece’s other end at the
back of the head as shown in P
. Sew both ends
C
back into the head.
P
complete the look.

Congratulations!
Y

A

W

Meet the designer

/> />
10

ASH WILLIAMS | ASH VS EVIL DEAD by tales of twisted fibers