Nghệ thuật xếp hình Nhật Bản: yuanbao2

Yuanbao (Ver 1.2)
Ronald Koh - 2000
c
2.
4.
3.
1.
Turn paper over.
Hold all layers firmly in position and
fold corner A down as shown, about
1/5th of the distance between line BD
and corner C.
5.
Crease firmly through all
layers and unfold.
6.
1/5
1/5
1/5
1/5
1/5
A
B
C
D
8.
Unfold to position at
start of Step 4, ...
9.
... then turn paper
over

10.
Bring each of the four
corners to a verticle
position, along the crease
lines made in Steps 6 & 7.
Now push the each
side to the middle to
bring the circled point
in the centre towards
you.
11.
12.
13.
Fold one layer all the way
down, drawing the corners
in at the same time to form
a neat triangle on each
side, ...
... like this.
14.
1/5
1/5
1/5
1/5
1/5
7
15.
Open out the over-
lapping layer on each
side as you fold up.

Fold the triangular piece into the pocket
immediately behind, then repeat from
Step 12 at the back.
Open out to form a
hollowed square at
the bottom.
16
17.
Push the upright
flaps outwards.
Finally, adjust the shape of the
yuanbao until it looks like this.