Nghệ thuật xếp hình Nhật Bản:pure land trex_2

Pureland T-rex by Marc Kirschenbaum (NY) ©1997
Simple
A 10" square makes a model 8" long
1. Precrease in half. 2. Valley to the center crease. 3. Precrease along angle
bisector. Only form crease on
the center region. Turn over.
6. Valley the corners outwards
as far as possible.
5. Turn over.4. Valley to the intersection of
creases.
9. Fold the indicated section in
half.
8. Raise the top flap.7. Turn over.
Crease A
18. Completed Pureland T-rex
©1997 Marc Kirschenbaum
17. Valley the head to taste.
Rotate the model.
16. Mountain fold the model in
half.
15. Pleat the bottom. Mountain
fold the tip.
14. Turn over.13. Pleat the top, so the
mountain fold hits crease A.
Valley the sides inward.
12. Swing down the back flap.
Turn over.
11. Valley outwards as far as
possible.
10. Turn over.