Cross cutting test according to DIN 53151 resp. ISO 2409

TIGER DRYLAC

Quality Control


Test instruction

Cross cutting test according
to DIN 53151 resp. ISO 2409



PA 01


1. Purpose / Target:
The cross cutting test serves multilevel painting on its background one on the other for the
evaluation of adhering in and as well as adhering the layers.
2. Description of the procedure:
2.1) Testing sets
Cut devices : Cutting device and folding ruler according to DIN 53151
Multi-cut device B according to DIN 53151

2.2) Execution
The coated sample boards are long stored at least 12 hours. For check the boards will provide
with a cut tape going through up to the background with 6 cuts and in the right angle in
addition with a further cut tape with 6 cuts. The cuts are to be drawn constantly and jerkily.

2.3) Analysis
The characteristic value is determined by regarding the cross cuts and their comparing with

the pictures and descriptions according to the analysis table (taken over from DIN 53151). If
the given characteristic value is not fulfilled, then is 2. To execute and evaluate check of the
same sheet metal.
3. Link documents:

DIN 53151
ISO 2409
Analysis table

Approved by:
Ing. M. Mathe
Issue date
April 95
Update status
01
Folder – Nr.
HQ 03 - 18
pagte
1/1