Tài liệu lilyfly_2 ppt

Lily-Fly page 1 of 3

Lily-Fly
by Kalei Anne Lundberg
copyright 2000
This model appeared while I was playing with the lily base and because I wanted
to send a butterfly to Sweden. The diagrams are offered for personal use any other
use please contact me for permission at
1. Do the star precrease, color
side up, and collapse the model
into a colored preliminary fold.
2. Fold and unfold to the
center line. Repeat on the
other side.
3. Inside reverse fold along
the precreased lines.
Repeat on the other side.
4. Fold and unfold to
the center line. Spread
squash fold along the
precrease.
5. Model after the spread
squash is complete.
Repeat on the other 3
sides. Note this is the lily
base with the small
points tucked to the
inside.
6. Fold a single layer on
the front and back left
side to the right. Note:

that the right side of the
model will now enclose
two full points
7. Valley fold the top
point down. This fold
will fall along the
interior thickness.
10. Petal fold.
11. Tuck the small point to the
inside.
12. Turn model over. 13. Valley fold the top layer to
the left to complete the
separation between the two
bottom wings.
14. Fold model in half.
9. Inside reverse the two
triangular folds between the
top and bottom set of wings.
Squash fold the bottom
triangular fold.
8. Open up the four
points. The model will lay
flat. Note: The reverse
side of the model should
be oriented as in step 13.
Lily-Fly page 2 of 3

15. Fold and unfold to
align along the edge of
the wings.

16. Outside reverse along the
precrease line while sliding the point
downward. This will cause a small
crimp fold on either side of the model.
Lily-Fly page 3 of 3

17. Note that the
crimp curls up over
the top wing and
tucks into the body.
18. Fold and unfold.
Light lines show the
landmark. Repeat on
back.
19. Reverse fold the tips
to the inside. The bottom
wings have an extra
reverse fold for the tip.
Repeat on back.
20. Reverse fold the
small tip between the
wings along line.
Repeat on the back.
Fold wings to the
right repeat on the
back.
21. Step reverse fold the
tip three times. Note the
second reverse will be
even with the body side of

the model. Open.
22. Shape the wings by sinking
the tips through all layers. Some
of these can be a bit tricky.
23. Ta Dah!!!!