Tài liệu Nghệ thuật xếp hình Nhật Bản: starbox_2 pdf

1
6 Pointed star box - base
Begin with a square creased into
quarters horizontally
only crease between these lines
2 3
4 5 6
Crease so line A runs parallel to line B
Inside reverse fold the
double layer by lifting
the top flap
7
8
9
10 11
Make the whole thing 3D
12
Make 5 more
Valley fold the 2 inner layers
A
B
© R.Glynn - July 1998
Fold the corner of the tab
over the hidden flap to lock
it in place
13
Slot 2 units together
15
16
Mountain fold flap
behind

Assemble remaining 4 units
6 Pointed star box - base
Assembly
© R.Glynn - July 1998
14
1
6 Pointed star box - lid
2 3
1/2
1/4
1/8
1/16
Make a small pinch 1/16
from the edge of the square
Fold the top edge to
the pinch mark
only crease between these lines
4 5
6
7
10
8
A
B
9
Unfold then valley fold left edge
using the circled guide point
11
12
13

Valley fold back up to the circled
guide point on layer below
14 15
Make unit 3D
Crease so line A runs parallel to line B
© R.Glynn - July 1998
16
6 Pointed star box - lid
Assembly
Insert tab into pocket
(mate the two turned over top edges).
Mountain fold behind to lock
17
Note how point tucks inside
neighbouring module
......Assemble remaining 4 units
© R.Glynn - July 1998