Tài liệu Appletalk pptx

APPLETALK

Key Commands Shows and Debugs

Appletalk routing
!
Appletalk routing eigrp 10
Appletalk route-redistribution <- don't forget!!!
!
interface ethernet 0
appletalk cable-range 10-20 10.1 <- specify node!
Appletalk zone Admin
Appletalk zone Marketing
Appletalk protocol eigrp
No appletalk protocol rtmp
!
On NBMA HUBS!!!
Appletalk local-routing
Interface serial 0
no appletalk eigrp-spplithorizon
no appletalk rtmp-splithorizon
Show apple route
Show apple interface s 0 <- most important command

Debug apple routing
Debug apple zip
Debug apple arp
Show appletalk interface
Show appletalk neighbor
Additional Commands

Static routes:
Apple static cable-range 10-20 to 50.1 zone MyZone
Apple static network 50 to 50.1 zone MyZone (Phse I)

AURP Tunnel:
Interface tunnel 0 <- no cable-range or zone on tun
No ip address
Appletalk protocol aurp
Tunnel mode aurp
Tunnel source 10.1.1.1
Tunnel destination 10.1.1.2

GRE tunnel. Do nor remove the "appletalk iptalk"
Interface tunnel 0 that is automaticaly
Tunnel source 10.1.1.1 placed on the int.
Tunnel destintion 10.1.1.2
Tunnel mode gre ip
Appletalk cable-range 20-30
Appletalk zone MyZone
Appletalk protocol eigrp <- can run either
No appletalk protocol rtmp

Dialer-list 1 protocol appletalk permit
!
frame-relay map appletalk 10.2 105 BROADCAST



Spot The Issue Notes
Cable ranges go from 1-253. 0, 254 and 255 reserv

Ping appletalk codes:
R: unrouteable
E: encapsulation failed
.: timeout
!: Echo received

When in doubt, reload.

On NBMA hubs: appletalk local routing


• Appletalk EIGRP requires UNIQUE EIGRP PROCESS
NUMBERS!!
• In "show apple zone" if a zone shows up with
a ":20" this represents a <space> entered at
the end of the zone name. Zone names must
match between routers! So, "Marketing" and
"Marketing:20" wouldn't agree.
• When you have a GRE tunnel established, try
to tunnel multiple protocols on it rather
than running parallel tunnels
• Doing a "no appletalk routing" then
"appletalk routing" re-initializes appletalk,
BUT, it takes out and replaces all basic
commands (like RTMP) but not commands related
to eigrp or aurp.
• AURP uses UDP port 387. Make sure it's NOT
filtered through an access-list!!
• AURP needs to be full mesh! Won’t router