Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (11.9 KB, 1 trang )
TIGER DRYLAC
Quality Control
Test instruction
Gloss level measurement
PA 06
1. Purpose / Target:
The gloss measurement serves for the determination reflecting power of a surface.
2. Description of the procedure:
2.1) Testing sets
Reflectometer
2.2) Execution
The test board must be cleaned with visible pollution before the measurement with a soft
cloth. The Reflektometer is adjusted before the measurement to a radius of 60°. For
measurement the test board is set on the measuring opening.
2.3) Analysis
The gloss degrees is read off from the display. Additionally to it the test board with a datum
locator (e.g. Vorproduktion...) is checked for possible rough visual deviations.
Approved by: