Tài liệu Quad Loop Extender Module (WQLX) pptx

Soneplex
®
WDM
Quad Loop Extender Module
(WQLX)
The Soneplex Single Fiber Quad Loop Extender (WQLX) module converts four multiplexed DS1 signals
into an optical DS2 using wave division multiplexing (WDM) optics. Similar to ADC’s Quad Loop
Extender (QLX), the WQLX transports the signal over single mode fiber, but uses only one fiber
instead of two. The same module is also used at the remote end to convert the optical DS2 back into
four DS1s at the customer premises.
ADC’s Soneplex system is the lowest total cost solution to expand local loop business services. In
addition to HDSL, HDSL2, HDSL4, traditional T1 repeater and optical DS2 technologies, Soneplex‘s
advanced diagnostics and management functions allow maximum control and visibility throughout
local networks. Focused on flexible, end-to-end solutions, the Soneplex system approach provides
robust, cost-effective transmission and access over either fiber or copper, using a single platform.
Features:
• Saves existing fiber plant by using half the fiber of other modules
• 1+1 protection switching
• 1310/1550 nm single fiber optical laser transport with optical budget of 18 dB
• Extensive network management with a Soneplex Shelf Controller Unit
• Supports central office and remote applications
• Central office and remote alarm capability
2
www.adc.com • +1-952-938-8080
6/02 • 4085
Soneplex Quad Loop Extender Module
Description
The protected mode requires a pair of WQLX modules at each end of the circuit. In a 1+1 line protected
system, identical traffic is transmitted across both the working and protect paths. Up to seven unprotected
or protected systems can be deployed from a single Soneplex Loop Extender system.
The Soneplex WQLX module is a fiber loop converter that provides cost-effective, reliable transmission of

four DS1 signals at distances up to approximately 22 miles (18 dB budget). The system can be configured
for either protected or unprotected service. The WQLX provides extensive alarms and diagnostic
capabilities.
Protection Switching:
Protection is accomplished using automatic protection switching (APS). APS is completed within 50 ms of
the decision and occurs when:
• A module fail condition occurs or the module is removed while on-line
• An optical failure occurs (optical loss of signal (LOS), optical out of frame (OOF), optical bit error rate
(BER) threshold exceeded)
• DS1 transmitter failure occurs
The unprotected mode requires one WQLX module per four DS1s installed in the Soneplex Loop Extender
chassis at the central office and one WQLX module at the customer (remote) end.
W
Q
L
X
CO
Customer Location
4 Electrical
DS1s
W
Q
L
X
RMT
Central Office
One Single Mode Fiber
Soneplex
Loop
Extender

System
Unprotected Configuration
W
Q
L
X
Soneplex
Loop
Extender
System
Customer Location
4 Electrical
DS1s
Central Office
CO
W
Q
L
X
CO
W
Q
L
X
RMT
W
Q
L
X
RMT

Protected Configuration
3
www.adc.com • +1-952-938-8080
6/02 • 4085
Soneplex Quad Loop Extender Module
Applications
Building Risers
The WQLX can also be used to distribute HiCap
DS1s to various floors in a building using the
Soneplex Loop Extender chassis with existing
fiber facilities. For flexibility, the same system
can also support copper transmission from the
same chassis. The Soneplex Loop Extender is
located in the building basement or a closet,
feeding one or more customers in the building.
The WQLX module is ideal for low-density T1 based applications such as PCS cell sites and building risers.
PCS Cell Sites
With the installation of the Soneplex Loop Extender system in the central office, a local exchange carrier or a
remote PCS service provider can serve a remote cell site using a WQLX remote module and a two or four
position chassis. As the PCS market continues to expand, the ability to establish cell sites and initiate service
quickly is essential. Since most sites require one or two T1 lines, the Soneplex Loop Extender with the WQLX
is ideal.
A majority of cellular sites are constructed with 24 VDC sources as the primary power supply. The requirement
to feed this growing application over a fiber network demands a system operating with a 24 VDC power
feed. ADC has developed unique WQLX modules to serve this application. The functionality is identical to the
-48VDC versions of the WQLX.
CELLULAR SITE
WQLX
Remote
1 - 4 DS1s

W
Q
L
X
Soneplex
Loop
Extender
System
CO
W
Q
L
X
CO
CENTRAL OFFICE/CEV/HUT/CABINET
CELLULAR SITE
WQLX
Remote
1 - 4 DS1s
24 Volt
Power
Supply
Optical
DS2
24 Volt Power Supply
Network Interface
1 - 28 DS1s
PCS Cell Sites
Soneplex
Loop Extender

System
WQLX Remote
1-4 DS1s
WQLX Remote
1-4 DS1s
HDSL or
HDSL2
Remote
28 DS1s
MUX
Building Riser
ADC Telecommunications, Inc., P.O. Box 1101, Minneapolis, Minnesota USA 55440-1101
Specifications published here are current as of the date of publication of this document. Because we are continuously improving our
products, ADC reserves the right to change specifications without prior notice. At any time, you may verify product specifications by
contacting our headquarters office in Minneapolis. ADC Telecommunications, Inc. views its patent portfolio as an important corporate
asset and vigorously enforces its patents. Products or features contained herein may be covered by one or more U.S. or foreign patents.
4085 12/02 Revised © 2002 ADC Telecommunications, Inc. All Rights Reserved An Equal Opportunity Employer
Web Site: www.adc.com
From North America, Call Toll Free: 1-800-366-3891 • Outside of North America: +1-952-938-8080 Fax: +1-952-946-3292
For a complete listing of ADC's global sales office locations, please refer to our web site.
Specifications
WQLX
Dimensions (HxWxD):
Weight:
Operating Temperature:
Operating Humidity:
DS1 Line Rate:
DS1 Line Codes:
DS1 Frame Formats:
Optical Wavelength:

Optical Budget:
Transmission Range:
Optical Line Rate:
Connectors Supported:
Input Power:
Power Consumption:
DS1s Per Module:
Modules per Chassis:
NEBS Level 1:
NEBS Level 3:
UL 1950:
4.4 x 1.4 x 9.2 in. (11.2 x 3.5 x 23.25 cm)
0.8 Ibs. (0.363 kg)
-40ºF to 149ºF (-40ºC to 65ºC)
5% to 95%, non-condensing
1.544 Mbps
AMI or B8ZS
SF, ESF, SLC96 or unframed
1310/1550 ± 40 nm
18 dB
Up to 22 miles, depending on fiber loss
6.312 Mbps
SC or FC
-42VDC to -56VDC
6 W
4
Soneplex Loop Extender; 7 without protection, 14 with protection
GR-63 Physical Protection
GR-63 Physical Protection, GR-1089 Electromagnetic Compatibility
General safety requirements for electronic equipment

Description Catalog Number
Soneplex Single Fiber Quad Loop Extender Module
CO & Remote -48VDC
CO with SC connector WQLXC-SCA100
CO with FC connector WQLXC-FCA100
Remote with SC connector WQLXR-SCA100
Remote with FC connector WQLXR-FCA100
Ordering Information