Basic of RIP routing
Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (64.37 KB, 2 trang )
Routing Information Protocol (RIP)
Exercise 1: Configure RIP on two routers.
Step 1: Configure IP address on all interfaces & PCs
In Router R1
R1(config)#interface fastethernet 2/0
R1(config-if)#ip address 10.0.0.1 255.0.0.0
R1(config-if)#no shutdown
R1(config-if)#exit
R1(config)#interface serial 1/0
R1(config-if)#ip address 20.0.0.1 255.0.0.0
R1(config-if)#clock rate 64000
R1(config-if)#encapsulation ppp
R1(config-if)#no shutdown
R1(config-if)#exit
In Router R2,
R2(config)#interface serial 1/0
R2(config-if)#ip address 20.0.0.2 255.0.0.0
R2(config-if)#encapsulation ppp
R2(config-if)#no shutdown
R2(config-if)#exit
R2(config)#interface fastethernet2/0
R2(config-if)#ip address 30.0.0.1 255.0.0.0
R2(config-if)#no shutdown
R2(config-if)#exit
Step 2: Run RIP Rip protocols on R1 and R2 .What rip will do is, it will create a routing
update by adding directly connected networks information and it will send to
neighbor routers.
In Router R1,
R1(config)#router rip
R1(config-router)#network 10.0.0.0
R1(config-router)#network 20.0.0.0
R1(config-router)#exit
In Router R2,
R2(config)#router rip
R2(config-router)#network 20.0.0.0
R2(config-router)#network 30.0.0.0
R2(config-router)#exit
Step 3: Verify network by using ip route to check routing tablet and ping command.
Exercise 2: Configure RIP on multiple routers.
