Tiêu chuẩn iso 00337 1981 cor1 1990
Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (180.2 KB, 2 trang )
INTERNATIONAL
STANDARD
TECHNICAL CORRIGENDUM 1
ISO 337 : 1981
Published 1990-10-15
INTERNATIONAL
ORGANIZATION
FOR STANDARDIZATION*
MEXaYHAPOfiHAFI
OPTAHM3A~Mfl
fl0 CTAHfiAPTM3A~MM.
Road vehicles - 50 semi-trailer
fifth
Basic and mounting/interchangeability
TECHNICAL
CORRIGENDUM
Whicules reu tiers d’in terchangeabilitk
Pivot d’attelage
RE’CTIFICA TIF TECHNIQUE
ORGANISATION
INTERNATIONALE
DE NORMALISATION
wheel coupling
dimensions
pin -
1
de 50 pour semi-remorque
-
Dimensions
de base et caractkristiques
de montage
et
7
Technical corrigendum 1 to International Standard ISO 337: 1981 was prepared by Technical Committee ISO/TC 22, Road vehicles,
Su b-Committee SC 15, lnterchangeability
of components
of commercial vehicles and buses.
Page I
Figure 1
Amend the dimension “84 -
0
1,5”
to read “84 -
0
1,5
***
“. (Footnote *** is explained on page 2.)
Page 2
Figure 3
Amend the dimension “139
UDC
” to read “139 -:,I*“.
(This means that the tolerante is in line with footnote *.)
Ref. No. ISO 337 : 198WZor.l
629.11.013.5 : 629.114.3
Descriptors
0
0 *
-0,5
: road vehicles, semitraiiers,
ISO 1990
Printed in Switzerland
couplings,
Pins, mountings,
dimensions,
dimensional tolerantes,
interchangeability.
: 1990 (E)
This page intentionally
left blank
