Mô hình tượng trên Đảo Phục Sinh, Chile. P1

Moai statues, Chile: Assembly Instructions

Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe

Before starting assembly:Writing the number of each section on its
back side before cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after cutting out
the sections.)

/>
Indicates where sections should
be glued together.

Parts 1 - 11
4

4

3

3
2
The surface of part 4 with
the triangle is the front side.
The surface of part 3 with the
red triangle on the glue tabs is the
front side.Keep these points in mind
when gluing the parts together.

View of completed model
*This model was designed for Papercraft and may differ from the original in some respects.

Assembly Instructions:Two A4 sheets(No.1 to No.2)

Glue parts 1 - 4 after
first gluing parts 5 and 6.
1

*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
Glue the dark-colored glue
tabs to part 10.

*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.

5
12

Parts 1 - 8

6
7

Assembly Instructions
Mountain fold(dotted line)

Make a mountain fold.
Valley fold(dashed and dotted line)

Make a valley fold.
Scissors line(solid line)

Cut along the line.
Cut in line(solid line)

Cut along the line.

Tools and materials
Assembly tip
Caution

Glue
The glue spot(colored dot)
shows where to apply the glue.

8

Glue spot(Red dot)

Glue parts with the same number together.

9

13

Glue spot(Green dot)

Glue within the same part.
Glue spot(Blue dot)

Glue to the rear of the other part.

10

14

Scissors, set square, glue(We recommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)

11

Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.

15
Glue so that the seams
on the rear surface match.

Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach of young children.

1


Moai statues, Chile: Assembly Instructions

Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe

* Build the two statues in the same way.

37

The surface of part 16 with
the triangle is the rear side.
Glue part 17 so that its seams
align with the triangle on part 16.

38

36

Parts16 - 24

35

16
32

First glue parts 18 and
19 together, then glue
to part 17.
17
17
18
34

33

19

20

29

21

25

Glue the dark-colored
glue tabs to part 23.
30

Parts 16 - 21
29
31

26
30 31

22
27

23
28

24
Glue so that the seams
on the rear surface match.

Finished!

2