Tiêu chuẩn iso 00007 1 1994 cor1 2007
Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (145.22 KB, 2 trang )
INTERNATIONAL STANDARD ISO 7-1:1994
TECHNICAL CORRIGENDUM 1
Published 2007-08-01
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION
• МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ
•
ORGANISATION INTERNATIONALE DE NORMALISATION
Pipe threads where pressure-tight joints are made on the
threads —
Part 1:
Dimensions, tolerances and designation
TECHNICAL CORRIGENDUM 1
Filetages de tuyauterie pour raccordement avec étanchéité dans le filet —
Partie 1: Dimensions, tolérances et désignation
RECTIFICATIF TECHNIQUE 1
Technical Corrigendum 1 to ISO 7-1:1994 was prepared by Technical Committee ISO/TC 5, Ferrous metal
pipes and metallic fittings, Subcommittee SC 5, Threaded fittings, solder fittings, welding fittings, pipe threads,
thread gauges.
Page 6
Figure 5
Replace the figure with the following:
ICS 21.040.30
© ISO 2007 – All rights reserved
Published in Switzerland
Ref. No. ISO 7-1:1994/Cor.1:2007(E)
ISO 7-1:1994/Cor.1:2007(E)
Figure 5 — Illustration of internal and external pipe threads (position of gauge plane, reference plane
useful thread)
2
© ISO 2007 – All rights reserved
